Forum

[patrick659]

Hello

We can open only one view window

In the configutation window the SX: Edit control does'nt work properly
it just jump from one size to an another speialy if you use arrow for up and down the value in the edit control.
If we have a refnce image like this :



If we could make more than one view window and be able to rotate
and translate this image in X+,X-,Y+,Y-,Z+,Z- in the space.And lock this point of view when we are satisfied
For eache view we can rotate translate the image in fonction of the modele it will be a very good thing.
There are also a drift between the image and the modele after fiew manipulations.
Zooming, panning.

[craouette]

you can have up to 5 views in A3D, all activated from the "views" menu.
each view has a diffrerent background setting.
What is the pb with Sx... I don't have any... can you describe the pb you have?
The background image can be rotated too..
and a view can be lock with the help of the lock icon in the view bar....


Regards,
Craouette

[patrick659]

The view does'nt work for me i can onlu have one ( the view specique one )
"Open view in new window". Or maybe it's work differently than i was thinking.

the probleme i got in Sx: edit control is
there is 1.0000 the image is big i put .5 that ok but if i touch the arrows on the right side it goes back to 1.0000 directly so it is difficult to adjust fine.

Yes the back ground can rotate in the plan of XY but not in Z.

Look at the image i send to you there are 3 plane drawing.
If i could defined more "Open view in new window" and for each plane view in it
we could rotate or translate the image for corresponding to the view of the plane
image rotate or translate for the plan xy, or xz,or yz. Now i must move or rotate the mesh for corresponding to the view.

Could be other solutuion to ?
Regards
Patrick