Forum

[patrick659]

Hello

If i make a Detach command and move the new one,after i am stuck
i can't select any other face,or verticed nor edge.



Patrick

Solution
i Have to goto "mesh" and select an another mesh.
But the new mesh should have been select or none of them not both.

[craouette]

Ok, in face mode, you can only work on one mesh at a time...
so it's normal that you can only work on the detached face(s).
but it is a bug that the other mesh still drawn with selected faces... I will correct this right away!

Craouette

[patrick659]

So we can't bridge 2 different mesh. ???

[craouette]

no, merge them before...
but you can use the extrude faces command...

[patrick659]

Merge cde doen't work with 2 Mesh.

I got another problem :
make a mesh with a sphere make som extrude.
make a plan cut
make an extrude on the detach face and on ide of the sphere on the detach
face is missing




Patrick